Yes, I have.
Look for the large (silver coloured?) inbus nut on the right side of the engine. It is below your waterpump.
Rework it or replace it so it has some thread in it. Now you can put in a "tube" (90 degrees) which is connected to a hose.
Make sure this hose is a metal shielded one (heat from the exhaust!!).
Then you can mount a sensor (normal car type, not that expensive) just behind the rear brake cylinder.
Do the electrical stuff and connect the gauge (comes with the sensor. For example VDO).
I used a 0-10 bar type which also has a minimum pressure setting. A led in the gauge comes on when the pressure is too low.
Ciao,
Patrick Kuyper
Vmax Club Holland
The Netherlands
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]
Sent: woensdag 19 april 2000 20:40
To: V-MAX TECH LIST
Subject: oil pressure gage
Howdy,
has anyone ever put an oil pressure gage on a Max ? if so could you share a
little info with us.
TIA
Dennis
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
