Tom
There is a spacer between the bearing and the cliper bracket and then another between
the
the bracket and the swingarm. Make sure you grease up the splines on the shaft side
before
you install the wheel. (You should get a manual)
Paulo
> Got some new wheels recently and went to put them on but on the right hand
> side the oil seal (where the rear caliper braket butts) seems to be missing
> and all I see is the bearing. When I start to tighten the axle the braket
> starts to push in until it butts the bearing. This causes the braket to
> interfere with the rotor.
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
