I now have max to the point that it will idle with no choke but only on 1
cyl.
I'm sure its a carb problem, when I enrich with carb cleaner or propane the
other cyls. kick in.
No vacuum leaks. The carbs are clean inside and out. Checked balance 3 or 4
times and is right on.
changed plugs, and wires just for kicks, no effect. Gas is fresh and clean,
Adjusted float level once but they are still a little off would this cause
a lean condition at idle? Is there any other place inside the carb air
could be leaking by? like the choke plunger or the coast enrichment valve?
I had them apart and they looked ok.
Don, Thank you for the Phone # I think I will call you tonight.
Rob F.
----------
>
>
> I cant get Max to run for crap. I am pretty sure it's a carb problem but
> cant find a cure
> The max was idling very poorly like on one cyl. Plenty of spark. Blew out
> pilot circuit, no help.
> Synk carbs, no help. Removed carbs disassembled blew out everything. New
> gaskets and O ring at jet
> block. New O rings at pilot screws. Put all back together now max wont
run
> unless choke depressed even when fully warm then doesn't run good at all.
> Float level may be a little low on one or two carbs but don't think that
> would cause it to run so lean Please help, I want to go to Americade in
two
> weeks but am stuck scratching my head with this. Thanks
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
