TC wrote:
>
> Charles,
> The only place I have seen it mentioned is in the E/EC supplement of
> the service manual on page 18.
> campbell
>
If I'm reading the service manual correctly (page 1 supplement), the
E/EC supplement only applies to starting serial numbers
JYA2WEE0*PA035101 (non CA) and JYA2WFC0*PA008101 (CA). My '93 is the
latter. I too had wondered about that line on page 18 "Preventing
over-revolution of the engine". I can say that one more than one
occasion, I have blown shifts and have momentarily hit 10.5-11K rpm. I
don't know at what RPM this alleged rev limiting takes place. I'm not
about to center stand my bike and rev my engine till it limits.
Although I am interested in finding out where this is supposed to
happen.
The Foreword of each supplement list which supplements, in addition to
itself, are needed to service the bike. Perhaps a factory rep can be
contacted for clarification. Although lately, I starting to believe
that this list knows more about the bike than the factory does.
--
=============================================================
Vmaxman (Pasquale Dell'Aquila) mailto:[EMAIL PROTECTED]
Homepage - http://www.Vmaxman.com Last Updated 5/25/2000
1993 Yamaha Vmax 1971 Yamaha DT1-E
1984 Honda Nighthawk S 1971 Yamaha DT1-MX
=============================================================
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
