Don ; I just used Tyler Pencock's measurement. I think it was 49mm or 48mm.
If I remember right I just turned the carbs upside down so the needles were
seated and measured of one of the edges where the float bowl cover goes I
think. When I had it apart it was obvious which edge since only one of my
floats was off. You can split the carb assembly in half and do two at a
time. It was easy. I never bothered to check them since all runs well. I
knew I had one that was rich because of the blue pipe on the front right
side. That was fixed. Cheers and good luck
Patrick Ahearn
VMOA # 570
Sarasota, Florida
My V-MAX Page
http://home.earthlink.net/~patahearn/
Where I work
http://msnhomepages.talkcity.com/ClassifiedsCt/floridacars/floridacars.html
----- Original Message -----
> I was reading your old posting about the stage 7 hybrid. You mention that
> you had an easy way to correct float height:
>
> snip> 7. For everything to work right your slides need to be free and
clean.
> You also need to synch your carbs. Float levels can have a effect on
> your idle mixture. After all is installed and you have this problem it
> can be corrected easily. Contact me for the solution.
>
>
> Please post your solution, or contact me directly.
>
> Don Seel.
>
>
> .............................................
> To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
> .............................................
>
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
