Thanks Rey!
What is involved in swapping out the flywheel? Is it a 3-hour job? 5-hour?
What will I need in the way of wheel-pullers & such? I've not yet cracked
open the engine or tranny, so this is my first venture in. Am I going to
need replacement gaskets or fluids? I just want to be prepared so the job
doesn't get interrupted. TIA
Hal
>-----Original Message-----
>From: Rey Kirkman [mailto:[EMAIL PROTECTED]]
>Sent: Wednesday, July 19, 2000 12:23 AM
>To: V-MAX TECH LIST
>Subject: Re: Lightened flywheel
>
>
>I think it is possible to do this yourself if you are a good machinest and
>have access to a good lath. However, you should first look at Furbur's 5.5
>lb flywheel. You will not be able to duplicate this with moderate skills.
>It only costs $175 or so.
>Regards,
>Rey Kirkman
>----- Original Message -----
>From: Hal Taylor <[EMAIL PROTECTED]>
>To: V-MAX TECH LIST <[EMAIL PROTECTED]>
>Sent: Tuesday, July 18, 2000 9:40 PM
>Subject: Lightened flywheel
>
>
>> Been mulling over the idea of a lightened flywheel after it was
>brought up
>> here. What all is involved in doing this? How long should it take
>someone
>> of moderate skill & temperment to complete? What tools will I need? Any
>> pointers? TIA
>>
>> Hal Taylor ([EMAIL PROTECTED])
>> Round Rock, TX
>> '99 Vmax
>> VMOA# 1171
>>
>>
>> .............................................
>> To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
>> .............................................
>
>
>.............................................
>To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
>.............................................
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
