Thx Mario. I finally got the end cap off by cutting the head off of a nail
and putting crossways in the baffle. Then pulling with a tool I have that
puts drive bands on conveyors. Came right off. That was when I figured out
that the end that the pipe goes into must come out as well.
At 07:35 PM 08/20/2000 -0400, you wrote:
>Scott Hallmark wrote:
>
> > OK gang I need some assistance. I am re-packing my Holeshot canister. I
> > have drilled out the rivets on the end cap. The thing is in really tight
> > and I don't want to scratch the can to hell and back as I have buffed to a
> > shiny finish. Any suggestions on getting the end cap off? Do I also need to
> > remove the cap where the pipe enters?
>
>If you remove the can from the pipe, you can use a round piece of wood and a
>rubber mallet from the front, to pop the baffle out of the canister, it is a
>lot easier than trying pulling from the back.
>
>Oiram
>
>.............................................
>To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
>.............................................
Scott Hallmark
[EMAIL PROTECTED]
http://home.earthlink.net/~scottvmax
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
