Hi Jon
Funny you should ask I had a older style DRL 400 and tried hooking it up
using Tylers diode install. I currently have a DRL 200 running with this
setup and it works great however it didn't like the DRL 400 when installed
in the same manner.For some reason the count is wrong (more or less halved)
so what I did was to use two (400 for the low limit and the 200 for the high
limit) Tyler suggested I try using two coil pulses to the one white
input sense wire going to the DRL 400 I haven't had a chance to try this
yet maybe today.My V-MAX is a 93 and it is turbocharged so I might be able
to also help with other questions you have there also.
GARY
VMOA 614
----- Original Message -----
From: <[EMAIL PROTECTED]>
To: "V-MAX TECH LIST" <[EMAIL PROTECTED]>
Sent: Sunday, September 03, 2000 4:23 PM
Subject: Dyna 400 connection
> I've been told that there is a way to connect a single 400 rev limiter to
an
> 86 model bike.
> Could someone give me a little guidance as to where I might find this
> information?
>
> Also any information or contacts on turbocharging a V-MAX would be much
> appreciated.
>
> Thanks,
> Jon Dell Blair
> Odessa TX
> [EMAIL PROTECTED]
> .............................................
> To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
> .............................................
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
