Scott, Try replacing the half disk with a full disk in the rear first
along with removing the retainer wire and spring plate and spacer in the
rear . That is if the clutch inspects ok . I have done this for a
coulple of people and it works . Cost is about $20 . If it dose not work
all you are out is the cost of the gasket .
Eric H.
----- Original Message -----
From: <[EMAIL PROTECTED]>
To: "V-MAX TECH LIST" <[EMAIL PROTECTED]>
Sent: Friday, November 03, 2000 9:52 PM
Subject: new clutch
> I seem to be experiencing a little clutch slippage . I was about to
install
> the barnet spring set up with the stock clutch plates.
> Now that I am having a problem i guess I should install a whole new
clutch
> pack with the barnett spring? If so what parts should i buy? Is
there a
> aftermarket clutch plates or are factory ones sufficient with the
better
> spring. My motor is internally stock with stage 7 and kerker. I dont
get to
> see the track so its mainly for street use. scott mellor
> .............................................
> To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
> .............................................
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
