Thanks, I was just using the slave as a reference point .
I'm replacing the cover due to crash damage .
Eric H
----- Original Message -----
From: "Pasquale Dell'Aquila" <[EMAIL PROTECTED]>
To: "V-MAX TECH LIST" <[EMAIL PROTECTED]>
Sent: Wednesday, November 22, 2000 7:49 AM
Subject: Re: Oil in cover - clutch slave
> Eric Harnish wrote:
> >
> > When removing the left rear case cover where the clutch slave is
located
> > is there supposed to be
> > a lot of oil inside ?
>
> The clutch slave in not inside the left rear case cover, it's located
> behind the case on the left side. Follow the clutch line and you will
> see where it attached to a cylindrical device about 1.75" in diameter
> and about 2.5" long. It attaches to the case via two 10 mm alan head
> screws. Take a look at the microfiche.
>
> Yes, there's lots of oil inside the case. Oil must be drained before
> removing either of the side covers.
>
> PDA
> --
> =============================================================
> Vmaxman (Pasquale Dell'Aquila) mailto:[EMAIL PROTECTED]
>
> VMOA #1282
>
> Homepage - http://www.Vmaxman.com Last Updated 5/25/2000
>
> 1993 Yamaha Vmax 1971 Yamaha DT1-E
> 1984 Honda Nighthawk S 1971 Yamaha DT1-MX
> =============================================================
>
> .............................................
> To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
> .............................................
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
