Larry,
The procedure for checking the valves is outlined in the service
manual. You can determine TDC by using the flywheel marks, (there are
two .. 70 degrees apart of course), or since you have the valve
cover(s) off anyhow it is quite easy to see when each set of valves is
sitting on the bottom ramp of the camshaft ... FYI .. the shim,
(lifter disc), chart in the manual is not accurate ....... I would
also recommend actually using a torque wrench on the valve covers ....
they live for the opportunity to warp ......
IMHO as always ...
campbell
----- Original Message -----
From: "Larry Langley (langleyl)" <[EMAIL PROTECTED]>
Subject: setting valves
> what is the procedure for setting valves i know the piston
> should b TDC but how do u know when your there? and how do u
> get there?ive set valves on a MUZ single cylinder timing
> belt w/dot on belt when u were TDC u advanced piston via the
> kick start. how do i get to TDC on a v max is the procedure
> outlined somewhere with all info needed to do this or should
> i just send her to dealer(god forbid).
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
