Howdy:
I had a similar problem when I first got my trailer. I actually bent the
clips a little to allow them to go over the ends of the handle. Later I
discovered that the problem was that there was material, no doubt paper,
preventing the slide gate from completely seating, thus causing the gate and
handle to be slightly ajar. When this obstruction finally cleared, the gate
fully closed and I was able to employ the clips with no problem. Then I had
to bend them back to their original shape so that they would stay put on the
handle ends.
Could be a similar situation?
GQ '67 Safari
----- Original Message -----
From: <[EMAIL PROTECTED]>
To: "Multiple recipients of VACList" <[EMAIL PROTECTED]>
Sent: Tuesday, April 24, 2001 8:27 AM
Subject: [VAC] Re: Dump Valve Question
>
> We're aware of the two clips on the "T" handle that are designed to
prevent
> the dump valve from opening inadvertently. However, for whatever reason
> we've never been able to get them over the ends of the "T" handle. Any
> suggestions, folks?
To unsubscribe or to change to a daily Digest, please go to
http://www.airstream.net/vaclist/listoffice.html
If replying back to this message, please delete all the unnecessary original
text from your reply.
