On Saturday 31 March 2007, Ron wrote: > Luis Gallardo <[EMAIL PROTECTED]> writes: > > Javier, you haven't told us what your host system is...but if you're > > using Linux here you are: > > > > I set my networking with bridging. My script in the Linux host is: > > > > Host: > > > > tunctl -t tap0 -u lgallard > > chmod 666 /dev/net/tun > > /sbin/ip link set tap0 up > > /sbin/ip addr add 172.16.16.16/32 dev tap0 > > echo "1" > /proc/sys/net/ipv4/conf/tap0/proxy_arp > > echo "1" > /proc/sys/net/ipv4/ip_forward > > parprouted eth0 tap0 > > echo "tap0 is set" > > Luis - Thanks for the information above. I tried typing it in by hand and > got errors with the "echo" lines. Do you run your script by hand or have > it setup to run during startup. If the latter, where do you put your > script?
This is a script. I had to make sudo for most of the lines and the ip calls did not completely set it up but one ipconfig line did. _______________________________________________ vbox-users mailing list [email protected] http://vbox.innotek.de/mailman/listinfo/vbox-users
