>> * Uncomment the following define if you want chkuser ALWAYS enabled. >> * If uncommented, it will check for rcpt existance despite any >> .qmail-default >> * setting. >> * So, unsomments this if you are aware that ALL rcpt in all domains >> will be >> * ALWAYS checked. >> */ >> #define CHKUSER_ALWAYS_ON > > > > This setting makes chkuser works aways, without checking bouncing or > catchall within .qmail-default. > > Comment it, and be sure bouncing is enabled everywhere except the > catchall domain.. > > >> /* >> * Uncomment the following line if you want chkuser to work depending on >> a VARIABLE setting >> * VALUE HERE DEFINED is the name of the variable >> * Values admitted inside the variable: NONE | ALWAYS | DOMAIN >> * NONE = chkuser will not work >> * ALWAYS = chkuser will work always >> * DOMAIN = chkuser will work depending by single domain >> settings >> * if CHKUSER_ALWAYS_ON is defined, this define is useless >> * if CHKUSER_STARTING_VARIABLE is defined, and no variable or no value >> is set, then chkuser is disabled >> */ >> #define CHKUSER_STARTING_VARIABLE "ALWAYS" */ > > > As you comment out the previous define, be careful to comment/use this > one in the right way. > > If you comment it, be sure bouncing is enabled for each needed domain. > > If you don't comment it, change it to > #define CHKUSER_STARTING_VARIABLE "CHKUSER_START" > > and set a variable called CHKUSER_START = "DOMAIN". Then set up bouncing > for each needed domain. How do i enable it for all domains but one. And where do I do that in the .qmail-default file?
> > Tonino > > >> Jimmy > > > > >