First apply other patches, then apply chkuser manually.
See for more info.



Kis Peter ha scritto:

I would like to ask for some help!

I have succesfully installed chkuser 2.0.9 on a clean Netqmail-1.05 without any problem.
After "make" and "setup", it works fine!

But if I first install "qmail-smtpd-auth-0.59" patch on a clean Netqmail-1.05, then
I try to install Chkuser 2.0.9, I got lot of error messages.
Chkuser 2.0 patch installation fails.
See output below.

# patch <./chkuser-2.0.9-release.patch
patching file CHKUSER.automatic_patching
patching file CHKUSER.changelog
patching file CHKUSER.copyright
patching file CHKUSER.log_format
patching file CHKUSER.manual_patching
patching file CHKUSER.readme
patching file CHKUSER.running
patching file Makefile
Hunk #2 succeeded at 308 (offset 4 lines).
Hunk #3 FAILED at 1548.
1 out of 3 hunks FAILED -- saving rejects to file Makefile.rej
patching file TARGETS
Hunk #1 succeeded at 386 (offset 1 line).
patching file chkuser.c
patching file chkuser.h
patching file chkuser_settings.h
patching file conf-cc
patching file qmail-smtpd.c
Hunk #2 succeeded at 39 with fuzz 2 (offset 5 lines).
Hunk #3 FAILED at 259.
Hunk #4 succeeded at 366 (offset 98 lines).
Hunk #5 succeeded at 377 (offset 98 lines).
1 out of 5 hunks FAILED -- saving rejects to file qmail-smtpd.c.rej

I think, that both of these two patches try to patch the "qmail-smtpd.c" file, and
they confuse each other.

What can be the solution for this problem?

Kis Peter

Vujity Tvrtko: Angyali történetek... és ami azóta történt. A népszerű riporter legszebb, legemberibb történeteinek folytatása. <,1,6022,295811,361564/click.prm>

[EMAIL PROTECTED] Interazioni di Antonio Nati [EMAIL PROTECTED] ------------------------------------------------------------


Reply via email to