[Adding vdsm-devel]

On 04/09/2013 03:40 PM, Sahina Bose wrote:
Hi all,

I'm testing the bootstrapping of host without reboot on Fedora 18. After
host's bootstrap,
Ifconfig output returns this:

ovirtmgmt: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
          inet 10.70.37.219  netmask 255.255.254.0  broadcast 10.70.37.255
    <snipped>

virbr0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
          inet 192.168.122.1  netmask 255.255.255.0  broadcast
192.168.122.255
         <snipped>

Running*glusterHostsList*  vdsm verb, returns the ip address
192.168.122.1, whereas my host has been added with ip address 10.70.37.219

If I reboot the host, the virbr0 bridge is removed, and there's no issue.

The vdsm verb glusterHostsList - returns ipAddress of host + output of gluster peer probe. This is needed because a periodic sync job needs to make sure that the hosts added in engine are in sync with the gluster cli (hosts could also be added/removed from gluster cli).

How can we make sure glusterHostsList picks the correct ipAddress? Reading the inetinfo based on bridge has been vetoed as we are doing away with bridges.

It would also work if virbr0 was updated in vds_interfaces table. Since this is not happening either - we have an issue.

thanks
sahina



_______________________________________________
Engine-devel mailing list
engine-de...@ovirt.org
http://lists.ovirt.org/mailman/listinfo/engine-devel

_______________________________________________
vdsm-devel mailing list
vdsm-devel@lists.fedorahosted.org
https://lists.fedorahosted.org/mailman/listinfo/vdsm-devel

Reply via email to