I have 4 drives and am multiplexing things so all drives are in use
which i suppose is how i backed things up in 8 hours and yes i gave 2048
set for frag size ( which i've just thought is 2 meg not 2 gig isnt
it....one to change )
I have worked out the duplication has picked its first image, then
mounted that tape and found other images on that and has started
duplicating them. What it hasnt done is realize other images to be
duplicated ( found with the bpduplicate -PM option ) are on different
tapes and then mount them in the other drive.
What i have done is to launch another bpduplicate with the -policy flag
as i have worked out they are on different tapes than the ones already
in progress. I assume when the original job tries to duplicate ones
further down the list it will realize a job has already begun to do
that.....I hope so anyway.
The percentage figure jumped from 1% to 6% when it had finished the
first tape on the sets it is doing.
That still was going to be out of time however as 6% in 140 minutes
meant it would take 38 hours for the whole thing to complete. ((100/6) *
140) / 60
This is bad as im moving everything tomorrow at 4pm eek.
D
Ed Wilts wrote:
On Wed, Feb 01, 2006 at 12:14:25PM +0000, Dave Markham wrote:
People i am moving an infrastructure from one site to the other. As part
of this we are splitting things between different trucks for resilience.
How long did this backup take?
I am slightly concerned as it reckons the job is only 1% through on the
gui.
I never trust the % complete. It's rarely right.
When i run iostat -xn |egrep "rmt/0|rmt/2" i can see around 5mb/s which
is about right for the DLT7000 drives i have in the L1000.
There are 32 images in total to duplicated and the backups took around 8
hours to complete 290 gig.
At 5MB/sec, that's 18GB per hour. To back up 290GB would take 16 hours.
I don't see how you completed this in 8 hours unless you were doing a
lot of compression.
I need the duplications to be finished by
tomorrow and as it has been nearly 2 hours now and saying only 1%
complete im worried it wont be done.
Can you estimate the actual speed by how fast it's changing tapes? A
DLT7000 is only 80GB compressed so you should be changing tapes every few
hours. 290GB in 8 hours is 36GB per hour so that would be a fresh tape
every 2 hours tops.
I am wondering what file num = Surely its not actually a file number
and its only written 23 files in 2 hours.
Are those 2GB file fragments? If so, that's about right - 46GB in 2
hours or 23 GB per hour - that's better than 5MB/sec. That would put
your total time to complete at about 13 hours.
.../Ed
_______________________________________________
Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
