Check on the netapp side, what does it report. Does it show the tape drive as in use. Is there an active ndmp job using the tape drive. Try the storage show tape command And the sysconfig -t command
Try the ndmpd status and session kill commands len From: veritas-bu-boun...@mailman.eng.auburn.edu [mailto:veritas-bu-boun...@mailman.eng.auburn.edu] On Behalf Of Joseph Despres Sent: Friday, April 24, 2009 8:53 AM To: veritas-bu@mailman.eng.auburn.edu Subject: [Veritas-bu] Tape drive is assigned with a tape loaded ...Yet no tape in the tape drive... Master = NetBackup-Solaris9 6.0MP6 Tape drive is attached to NetApp Filer... And is controlled from the Master... Tape drive shows in vmoprcmd that it has a tape loaded... And bpdbjobs shows a job associated with that tape drive... Yet nothing is running and has been hung out there for a bit... I attempt to resetbyname and get the following: "Drive is currently assigned" And also I cannot kill the jobs...... Is there a way to clear this up? Thanks..... Joe Despres Backup Engineer CSC 3521 Ribcowski Ct Raleigh, NC 27616 GIS | (o): 1.919.266.1799 | (c): 1.919.931.9674 | jdesp...@csc.com | www.csc.com This is a PRIVATE message. If you are not the intended recipient, please delete without copying and kindly advise us by e-mail of the mistake in delivery. NOTE: Regardless of content, this e-mail shall not operate to bind CSC to any order or other contract unless pursuant to explicit written agreement or government initiative expressly permitting the use of e-mail for such purpose.
_______________________________________________ Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
