Just a data point for you. We're still on ACSLS 7.3 under Solaris 10 and have had zero issues going from 6.5.4 -> 7.0 -> 7.0.1 -> 7.1 -> 7.1.0.1. The robot definitions were defined soley through the gui after the initial 7.0 upgrade and don't have anything specific to the robot in the vm.conf.
John On 10/03/2011 02:03 PM, Rusty Major wrote: > Hi All, > > > > Fresh install of NBU 7.1 with ACSLS 8.0.2, both on Solaris 10. I am unable to > get NBU to communicate with ACSLS without forcing > the port to communicate over in vm.conf (ACS_CSI_HOSTPORT). This works fine > until the ACSLS application is restarted and the port > changes. > > > I noticed with NBU version 7.1.0.0, MM and ACS daemons would not even start > up, but when I patched to 7.1.0.2, all the appropriate > daemons started, but there was still no communication with ACSLS without the > above mentioned vm.conf entry. ACSLS is configured > with default settings. > > > > I have an ACSLS 8.0.2 server working with NBU version 6.5.x without any > issues (same default ACSLS settings and no entries in > VM.CONF). > > > > Has anyone run across this and have any pointers? > > Thanks, > > -Rusty > > > > _______________________________________________ > Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu > http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu _______________________________________________ Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu