Ronald Do you know how to on this G3 ESL, because I have gone through the Manual and I cannot see anything about it, and HP is saying it is a NetBackup issue, but I keep stating it is not :( ________________________________ From: [email protected] [[email protected]] on behalf of Roland Kastner [[email protected]] Sent: 05 November 2013 15:36 To: Simon Weaver Cc: [email protected] Subject: Re: [Veritas-bu] HP ESL G3 Tape Library Barcode Issues
Hi Simon, you can change the Barcode reading direction on the GUI of the ESL tape Library (left to right) Mit freundlichen Grüßen/With kind regards Roland Kastner From: [email protected] [mailto:[email protected]] On Behalf Of Simon Weaver Sent: Dienstag, 5. November 2013 16:31 To: Stier, Matthew Cc: [email protected] Subject: Re: [Veritas-bu] HP ESL G3 Tape Library Barcode Issues Matthew I do not have anything like this in VM.conf I have existing Tape Libraries, that are reading the last 6 digits of the Barcode just fine. If I create a Media ID Generation Rule, then this means I am trying to move away from the default behaviour of NetBackup? I want to read W995L5 - But I am SSW995 in the Media ID and Barcode Colums under Media and Device Management, then under Robots and under Robot TLD(1) Simon ________________________________ From: [email protected]<mailto:[email protected]> [[email protected]] on behalf of Stier, Matthew [[email protected]] Sent: 05 November 2013 15:11 To: Simon Weaver Cc: [email protected]<mailto:[email protected]> Subject: Re: [Veritas-bu] HP ESL G3 Tape Library Barcode Issues Documented here: http://www.symantec.com/business/support/index?page=content&id=TECH10824 From: [email protected]<mailto:[email protected]> [mailto:[email protected]] On Behalf Of Simon Weaver Sent: Tuesday, November 05, 2013 10:01 AM To: [email protected]<mailto:[email protected]> Subject: [Veritas-bu] HP ESL G3 Tape Library Barcode Issues Hi All Hope everyone is well. Can someone advise on this? I have implemented an HP G3 ESL Library under NBU 7.5 - However, I have a problem. When doing the Inventory, it is showing the Media ID as the first 6 characters of the Barcode, rather than the last 6 characters of the Barcode. For example, what I expect to see is W955L5, but what I am seeing is SSW995 being imported! Any ideas as HP is telling me it is a NBU issue, but I was under the impression that by design, NetBackup imports the last 6 characters of the barcode. Thanks, Simon
_______________________________________________ Veritas-bu maillist - [email protected] http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
