Hi All; Received and installed standard jaws on my Nor vise, big difference. Studied Norm's videos but, I'm still struggling to use it.
A couple questions: How do you figure out when the bobbin is set up correctly? Tried using the vise to load bobbins, seemed very difficult, cordless drill works ok. When touch dubbing, how long does it take for the thread to grab the dubbing? Any suggestions on a pattern to master some techniques? Anyone use the dubbing block, if so opinions? Thanks in advance; Wayneb Sent from Yahoo Mail on Android -- -- You received this message because you are subscribed to the "VFB Mail" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/vfb-mail?hl=en VFB Mail is sponsored by Line's End Inc at http://www.linesend.com --- You received this message because you are subscribed to the Google Groups "VFB Mail" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
