I use straight shank hooks with foam poppers. I use a 1/64 inch drill bit in my Dremel and drill a hole thru the foam. Put a few layers on thread on the hook and then Zap-a-gap the foam to the hook. Works for me. Rick
On Thu Jun 01 2017 21:18:29 GMT-0500 (Central Daylight Time), Jack Lehman <[email protected]> wrote: Well, I'm about out of my old stinger hooks. The 8089 and B10S are good for some poppers, but the short shank limits my options. And I don't like the kink-shank hooks for the foam poppers I usually tie. Anyone found any other options? Thanks Jack Austin -- -- You received this message because you are subscribed to the "VFB Mail" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/vfb-mail?hl=en VFB Mail is sponsored by Line's End Inc at http://www.linesend.com --- You received this message because you are subscribed to the Google Groups "VFB Mail" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- -- You received this message because you are subscribed to the "VFB Mail" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/vfb-mail?hl=en VFB Mail is sponsored by Line's End Inc at http://www.linesend.com --- You received this message because you are subscribed to the Google Groups "VFB Mail" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
