Henk
I flux all hard or soft soldered joints, ensuring a good contact and dense
joint. If you use flux-cored solders you only need to ensure clean greese
free contact points
iain
On 4 May, 2007, at 14:13, iain short wrote:
use low temp silver solder and the correct flux. use fine emery paper to
clear all plating, chemical coatings or paint off the hook shank.
Do you think that for this type of application, a flux is necessary?
There's no real capillary contacts.
Cheers
henk
=============================== ><(((((º> ===============================
| Dr. Henk J.M. Verhaar | e-mail: [EMAIL PROTECTED] |
| Ecotoxicoloog en vliegbinder | tel: 035 656 2128 |
| Stichts End 17 | mobiel: 06 26 136034 |
| NL-1244 PK Ankeveen | web: www.xs4all.nl/ ~flyrod |
=============================== <º)))))>< ===============================
_________________________________________________________________
Could you be the guest MSN Movies presenter? Click Here to Audition
http://www.lightscameraaudition.co.uk
