Hi I have the same card, except i'm on a redhat system. try going to the developer's website and download the newest zoran drivers, and install them after compiling the kernel. Then modprobe saa7110 and THEN modprobe zoran and it should take a little time to load. then go ahead and play around with xawtv, lavrec, zapping, and so forth. Good luck marcel
Stephen Johnson wrote: >hello and thanks in advance for any help offered. >i'm an intermediate-advanced debian user running 2.4.18 kernel. >however, i'm new to computer video capture. >i picked up a dc10plus pinnacle sys card(for analog capture)that came >with a studio av version 7 pack. i do have that other os loaded on a >partition for this and its working with pinnacle's drivers. >then i found out it's supported under linux, yeah! anyway, the driver >developer's site is a bit confusing to me, the card shows up in >lscpi(below) > >02:0b.0 Multimedia video controller: Zoran Corporation ZR36057PQC Video >cutting chipset (rev 02) > Subsystem: Miro Computer Products AG DC10 Plus > Flags: bus master, fast devsel, latency 0, IRQ 3 > Memory at d5800000 (32-bit, non-prefetchable) [size=4K] > >but there's so many modules that seem to point to this config, so i >compiled in almost everything(as modules) related to video4linux,zoran, >and dc10 including all the i2c stuff. i tried loading different module >configs and nothing seems to work when using xawtv or anyting else. i'm >assuming i might need some special module params, which i've never done >before. also i'm not sure wich devices i need, the devices.txt file in >/usr/src/linux/Documentation says there are devices for dc10 /dev/dc100 >/dev/dc101 ... at major 94 and v4l uses /dev/video0... on major 81. i >tried both and neither seems to work(using symlink /dev/video to each). >so probably has something to do with module params, right? any >suggestions? > >thanks > _______________________________________________ Video4linux-list mailing list [EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/video4linux-list
