Jon Pennington wrote:
> On Thu, Jan 18, 2001 at 10:03:12PM +0000, Steven Cockeram wrote:
>
>> I've got an old DC10 with the ZR36016, ZR36057, ZR36050 combination
>> using a VPX3216 and MSE3000 for decoding and encodeing the analogue
>> signal. I've found some datasheets on these - but it seems like a lot of
>> work getting anything going.
>
>
> Don't mind me; I'm a bit mad. Are you not trying to use a Miro card? Does your
>card have the ZR36057 or similar MJPEG stuffs that the Miro's have? If so, why not
>work from the Unified driver? If not, why are you starting here instead of the bttv
>or similar driver?
>
The standard Miro DC10/DC10Plus use a philips SAA7110 for the analogue
to digital decoding and a ZR36060 jpeg codec. My card uses the VPX3216
and a combination of a ZR36050 and a ZR36016 for the jpeg stuff. This
card is really a cut down DC30 (The board has DC30D printed on it), that
was sold as a DC10.
I have played around with the Unified driver and I think that is where I
may make some progress. I need to find some VPX32XX i2c initialisation
code. The spec sheet doesn't really go into this (albeit only after a
first casual glance), whereas the SAA7110 spec sheet has example i2c
code for different modes - probably the reason why progress has been
made on this chip.
>
>> I'd like to start off using some V4Linux driver and then adapting it.
>> I've looked at the DC10plus driver and a (very old DC30) driver.
>
>
> I'm sure I'm not the only one with these questions...
>
I'm sure I'm not the only one with this card - if anyone else has made
progress I would be grateful to hear from them.
Steve.
_______________________________________________
Video4linux-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/video4linux-list
