Hi ANDY!
On Mo, 06 Jun 2011, ANDY KENNEDY wrote:
> All,
>
> <if this hits the list twice, my bad, it didn't post the first
> time>
>
> Buildroot uses Config.in as the Kconfig files. Setting the line:
>
> au BufNewFile,BufRead Kconfig,Kconfig.debug setf kconfig
>
> to:
>
> au BufNewFile,BufRead Kconfig,Kconfig.debug,Config.in setf kconfig
>
> Works for these Kconfig files in Buildroot.
>
> HOWEVER, for some strange reason if there is a comment at the top of
> the file, the file is no longer recognized as a Kconfig file, but as
> a <something> source file. I knew what it was last week, but cannot
> recall at the moment. I want to say it was Python or something. I
> removed lines from filetypes.vim until I found the culprit. The match
> case is looking for # in column 1 of lines 1 and 3. Since I had a
> multi-line comment, it matched. The bummer part is I couldn't figure
> out how to make the Kconfig be higher weight than the one that matched
> it. I attempted to move the au line above to the top of the section,
> but this yielded nothing. Do I need to move the line:
>
> au BufNewFile,BufRead Kconfig.* call s:StarSetf('kconfig')
>
> In stead?
>
> If you know of a fix for this, please pass it along to me.
Instead of :setf use :set filetype=
You might also want to read up on :h new-filetype
regards,
Christian
--
You received this message from the "vim_dev" maillist.
Do not top-post! Type your reply below the text you are replying to.
For more information, visit http://www.vim.org/maillist.php
