On 2013-09-17 15:59, Ben Fritz wrote:
On Tuesday, September 17, 2013 12:17:57 PM UTC-5, Matthew Woehlke wrote:
I just discovered that text wrapping has changed at least between
vim-enhanced-7.3.1314-2.fc18.x86_64 and
vim-enhanced-7.4.016-1.fc18.x86_64 (so probably between 7.3.x and 7.4.0).
It used to be the case that if I typed some text that was almost long
enough to wrap, then went to the beginning of the line and added some
text, then went to the end of the (now over-length) line and typed some
more text, vim would wrap the text when I typed at the end.
It has stopped doing this. Was this change intended? It is very annoying
when writing git commit messages; I have had to newly enable fo+=a as a
work-around.
Do you have 'l' in your formatoptions? In 7.4.0 I see your expected
behavior with "set fo=t" unless I then do "set fo+=l".
Ah, I do... apparently this is now on for gitcommit where it used to be off?
Still, I'm not sure fo+=l is working correctly. The documentation says
"When a line was longer than 'textwidth' when the insert command
started, Vim does not automatically format it." But I am seeing this
even when I enter insert mode with an initially empty document and never
leave insert mode?
--
Matthew
--
--
You received this message from the "vim_dev" maillist.
Do not top-post! Type your reply below the text you are replying to.
For more information, visit http://www.vim.org/maillist.php
---
You received this message because you are subscribed to the Google Groups "vim_dev" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/groups/opt_out.
