On Friday, April 12, 2013 12:55:11 PM UTC-4, Tim Chase wrote: > > > I just installed macvim in my mac pro 13 and I met a problem that > > > when I quit vim, it does not restore the previous commands I typed > > > in terminal. > > > > > > For example, > > > > > > $ls > > > a.data b.data > > > $vim a.data > > > > > > this is a story > > > > > > Then I quit a.data, it still shows: > > > > > > this is a story > > > $ > > > > > > How should I change settings so the previous commands like "ls" > > > will restore? > > > > This may depend on your termcap for terminal. By default, I believe > > Vim does this if it knows how. You can read up at > > > > :help xterm-screens > > > > the behavior of which is controlled by the 't_ti' and 't_te' > > settings. They're likely blank. If so, and your terminal supports > > swapping banked screens, you set the corresponding escape-sequences > > in your vimrc (perhaps wrapped in an if...endif block to detect your > > particular environment). Alternatively, perhaps at one point you set > > these to blank values in your vimrc, and you can just remove the > > overriding lines to restore factory behavior. > > > > -tim
Thanks Tim. I have just reinstalled vim with homebrew and it is working properly now. -- -- You received this message from the "vim_use" maillist. Do not top-post! Type your reply below the text you are replying to. For more information, visit http://www.vim.org/maillist.php --- You received this message because you are subscribed to the Google Groups "vim_use" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
