Clark Martin wrote:
> A hint for next time. Assuming this is a DIP 14 or DIP 8 package > size oscillator, cut the pins off, remove the oscillator and then > desolder the individual pins from the board. You waste an oscillator > but it's much easier on the board. Then install a socket to hold the > new oscillator. This way if the board doesn't work at the higher > clock speed you can revert to the original speed with a new > oscillator. > -- > Clark Martin And I HAD the socket. But its back legs were a larger diameter than the front, and larger than the original 4-pin oscillator. I feared the holes would become too wide to allow contact. As it was, I drilled the holes with an orifice drill so the new oscillator would slide in without interference. Jeff -- Vintage Macs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Enter To Win A | -- Canon PowerShot Digital Cameras start at $299 | Free iBook! | Support Low End Mac <http://lowendmac.com/lists/support.html> Vintage Macs list info: <http://lowendmac.com/lists/vintagemacs.shtml> The FAQ: <http://macfaq.org/> Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/vintage.macs%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
