To all who've replied so far, thank you very, very
much for your suggestions. I love this community!
The problem is still not resolved, unfortunately.
Here's what I've found out so far:
Pressing the recessed "Reset" button on the front panel
has not restored an image to the monitor.
I have also tried some variations of this (i.e.: holding the
Reset button in while doing a power cycle on the monitor,
or holding in the Reset button and keeping it pressed for
30 seconds, etc.).
I've also ruled out any problems with the video cable.
Here is some useful info from my troubleshooting:
1. The monitor can definitely still sense the presence of a
video signal. When the computer is powering up, after the
boot-time RAM test finishes, the yellow "standby" light goes
out and the green "ready" light comes on. The green light stays
on indefinitely then, until I power down or restart the computer.
2. Occasionally, I get the following VERY encouraging sign:
The CRT will sometimes display a very, very dim luminence that is
obviously a raster pattern (because I can see the horizontal
scan lines). You know how, on a properly-working monitor,
you can see a faint luminescent "border" around the image
(i.e. in the "dead space" between the edges of the CRT and the place
where the picture actually starts)? And if you turn up your
brightness control to "maximum", that black border around your
image starts to look more like "dark gray" instead of black?
Well... that's what my WHOLE screen looks like. So there is
SOME kind of activity going on... in other words, the CRT
itself is obviously not dead.
Can anybody, based on these further observations,
suggest what might be going on?
And does anybody know what that BIZARRE plaid monochrome
pattern that took over my screen might have been? It looked
like some kind of test pattern... like something you'd use to align
the monitor's settings, perhaps... maybe it was located in the monitor's
firmware?
Lastly, does anybody know if these monitors (Radius Intellicolor 20e)
have some type of internal lithium battery that keeps alive the
settings information? If so, then perhaps that battery's gone dead!
Where would I find the battery (if there even is one)?
Again, thanks so much in advance for your help.
I eagerly await your replies.
I'm in Digest mode, so I only get to see your postings once a day.
Cheers,
Greg Shafritz
--
Vintage Macs is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics http://www.smalldog.com | Enter To Win A |
-- Canon PowerShot Digital Cameras start at $299 | Free iBook! |
Support Low End Mac <http://lowendmac.com/lists/support.html>
Vintage Macs list info: <http://lowendmac.com/lists/vintagemacs.shtml>
--> AOL users, remove "mailto:";
Send list messages to: <mailto:[EMAIL PROTECTED]>
To unsubscribe, email: <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive: <http://www.mail-archive.com/vintage.macs%40mail.maclaunch.com/>
Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
