Hi, I've got a IIsi, 64meg, Presto 040, 7.6..... The Presto has a nice riser board with 2 PDS connectors which, I'm assuming, allows the use of an additional PDS card. However, when I plug my Asante MacConII (adaptor w/68882 FPU on board) into it, the system does not see the FPU chip. If I unplug the Presto and leave the MacCon plugged into the riser, the system sees the FPU just fine. I'm guessing the 040 can't pass off instructions to the FPU?
Is this normal? What will work in that extra slot? Haven't tried the ethernet part of the MacCon yet. I hope that works, but I have to do some slight hardware mods to make it physically fit. Also, any reason "not" to install OS8 on this system? Thanks in advance for all the good advice! Randall -- Vintage Macs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Enter To Win A | -- Canon PowerShot Digital Cameras start at $299 | Free iBook! | Support Low End Mac <http://lowendmac.com/lists/support.html> Vintage Macs list info: <http://lowendmac.com/lists/vintagemacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/vintage.macs%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
