Olly,
Thanks for the "how to". I am in the process right now. I don't have the
white rivits and if we don't find them, a touchup with white paint may be
in order. I put a new 6 gallon Atwood water heater in yesterday evening.
Got it all done except for an elusive gas connection fitting. I also found
it much easier to bring the feed line up through the bottom of the new
heater than use their predrilled hole. The old stainless steel cover looks
like it may fit. I will check that out this evening. Thanks again! Alot of
great information being dispensed here.
.........Brian........
73 Safari
At 05:50 PM 7/26/00 -0600, you wrote:
>
>
>Hi Brian,
>To pull the ceiling panel, you will need to remove the two forward light
>fixtures and the A/C cover. There are several rivets holding in the center
>overhead panel, you will need to drill them out. I replaced them with sheet
>metal screws with white heads so they would blend in. Then start from the
>forward end and work the ceiling panel off, but not off completely, off just
>enought to get your work done and button it back up again.
>
>good luck,
>
>Olly Larson
>99 Durango and 73 Safari
>
>
>
