OK, I've got two B2 Eber. gas heaters here, and the thermoswitch/quarz sensor
rods are NOT coming out without shearing the top off the inner chamber threaded
connection, (in fact I've already done this with one, so I suspect the heater
is instant junk). They are SO delicate here, yet it requires their removal to
service the switch. VERY poor design. After 30 yrs, the nuts are so siezed on I
would say your are NOT going to get them seperated from the inner chamber
threaded male fitting. If anyone knows who can service and hopefully repair my
little learning experience I would appreciate it.
Thanks,
Courtney
_______________________________________________
vintagvw site list
[email protected]
http://lists.sjsu.edu/mailman/listinfo/vintagvw
