I have already post this bug here https://bugzilla.redhat.com/show_bug.cgi?id=709734
but I did not answer. Description of problem: 1. The execution of the command "virsh iface-start br1" (br1 interface is obtained with "virsh iface-define") takes 10 minutes. 2. After restarting the machine, the interface does not start automatically even though I specified the parameter <start mode="onboot"/>. I have to manually run the command "virsh iface-start br1". If I create the interface with virt-manager, I have the same problems and the process takes about 20 minutes. Version-Release number of selected component: I have found the 0.8.8 version of libvirt and virsh in this repository: <https://fedoraproject.org/wiki/Virtualization_Preview_Repository> https://fedoraproject.org/wiki/Virtualization_Preview_Repository. I use this version because the 0.8.3 has a third bug. Fedora 14 Linux Kernel 2.6.35.13-91.fc14.x86_64 libvirt 0.8.8 virsh 0.8.8 virt-manager 0.8.7 bridge-utils 1.2 Steps to Reproduce: 1. Create the file bridgeInterfaceConfig.xml (change interface, ip and mac to correspond to your configuration) <interface type='bridge' name='br1'> <start mode="onboot"/> <protocol family='ipv4'> <ip address='192.168.1.15' prefix='24'/> </protocol> <bridge> <interface type='ethernet' name='eth2'> <mac address='00:1b:21:43:36:b0'/> </interface> </bridge> </interface> 2. launch "virsh iface-define bridgeInterfaceConfig.xml" 3. launch "iface-start br1". this step take 10 minutes. 4. restart the computer and see that the br1 interface no longer exists. 5. you can do the same with virt-manager.
_______________________________________________ virt-tools-list mailing list [email protected] https://www.redhat.com/mailman/listinfo/virt-tools-list
