I'm using: virt-manager 0.9.0 Fedora 16 KDE 4.7.4 network manager 0.9.2-1 I want to have bridged connections so my VMs can be on the same network segment as the host. I used the instructions on here: http://www.linux-kvm.com/content/bridged-networking-virt-manager-083 When I did that, it made my ethernet connection go away. It seemed to freeze up, so I stopped the process. After that I had no ethernet connection so I had to go into network manager and add it back in. When I tried it again, I once again lost my ethernet connection.
So I looked around on Linuxquestions.org and found instructions to do the following: create /etc/sysconfig/network-scripts/ifcfg-br0 by copying it from /etc/sysconfig/network-scripts/ifcfg-eth0 then edit both files to match what you need, something like I have listed below /etc/sysconfig/network-scripts/ifcfg-br0 Code: DEVICE="br0" ONBOOT=yes TYPE=Bridge BOOTPROTO=static IPADDR=192.168.10.40 GATEWAY=192.168.10.1 DELAY=0 /etc/sysconfig/network-scripts/ifcfg-eth0 Code: DEVICE="eth0" ONBOOT=yes TYPE=Ethernet HWADDR=00:12:13:14:AB:CD BRIDGE=br0 Then do 'service network restart' On my computer instead of DEVICE it has NAME. So I set it up like this: cat ifcfg-br0 TYPE=Bridge BOOTPROTO=none IPADDR0=192.168.1.17 PREFIX0=24 GATEWAY0=192.168.1.1 DNS1=192.168.1.7 DEFROUTE=yes IPV4_FAILURE_FATAL=yes IPV6INIT=no NAME=br0 ONBOOT=yes When I put the BRIDGE=br0 into my eth0, it stopped working correctly. What do I have to do to get this set up correctly? One other question - would I need to set up a brX for each VM? Thank you -- Eric Mesa http://www.ericsbinaryworld.com
_______________________________________________ virt-tools-list mailing list [email protected] https://www.redhat.com/mailman/listinfo/virt-tools-list
