> From: Heng Qi <[email protected]>
> Sent: Friday, February 17, 2023 12:17 PM
> Yes, but there seems to be such a situation: when the device is reactivated,
> as
> the specification says, all parameters are set to 0 (use parameters as the
> default
> configuration on the device).
> When CTRL_COAL_SET and CTRL_COAL_VQ_SET are sent, the configuration is
> updated (the parameters of each vq may be different, but the global parameter
> configuration may be recorded), at this time, if vq is reset, should the
> parameters be 0 or a recorded global parameters after it is re-enabled?
Recorded global parameters should be fine to report on an enabled vq even if
the COAL_VQ_SET was not done.
This is because the global value reflects on the VQ.
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
