On Thursday 19 May 2011, Arnd Bergmann wrote:
> >
> > # cat /proc/tile/board
> > board_part: 402-00002-05
> > board_serial: NBS-5002-00012
> > chip_serial: P62338.01.110
> > chip_revision: A0
> > board_revision: 2.2
> > board_description: Tilera TILExpressPro-64, TILEPro64 processor (866
> > MHz-capable), 1 10GbE, 6 1GbE
> > # cat /proc/tile/switch
> > control: mdio gbe/0
>
> I think it's ok to have it below /sys/hypervisor, because the information
> is provided through a hypervisor ABI, even though it describes something
> else. This is more like /sys/firmware, but the boundaries between that
> and /sys/hypervisor are not clearly defined when running virtualized anyway.
A minor point that I meant to bring up but had not gotten to:
When you do a /sys/hypervisor/ interface, put everything into a subdirectory
under /sys/hypervisor with the name of your hypervisor, to avoid naming
conflicts, e.g.
/sys/hypervisor/tilera-hv/board/board_serial
Arnd
_______________________________________________
Virtualization mailing list
[email protected]
https://lists.linux-foundation.org/mailman/listinfo/virtualization
