I read the instructions and got a clean compile for the snapshot from 17th
Feb2006
my visdn_configurator loads the modules and all looks OK.
My visdn.conf is
[general]
[global]
network_role = private
tones_option = yes
outbound_called_ton = unknown
force_outbound_cli =
force_outbound_cli_ton = no
clir_mode = default_on
cli_rewriting = No
national_prefix = 0
international_prefix = 09
network_specific_prefix =
subscriber_prefix =
abbreviated_prefix =
overlap_sending = Yes
overlap_receiving = No
autorelease_dlc = 10
call_bumping = No
echocancel = Yes
echocancel_taps = 128
[huntgroup:telco]
mode = sequential
members = visdn0
[visdn0]
network_role = private
context = from-pstn
tones_option = yes
outbound_called_ton = unknown
force_outbound_cli =
force_outbound_cli_ton = no
clip_default_name = vISDN
clip_default_number = 300
clip_numbers = 300
clir_mode = default_off
overlap_sending = Yes
overlap_receiving = No
my devices-pci-0000-XXXXX file is
<netdev visdn0>
protocol lapd
role NT
tei dynamic
</netdev>
<port st0>
attribute role NT
<chan D>
connectmodule netdev visdn0
</chan>
<chan E>
connectmodule netdev visdn0 echo
</chan>
</port>
But when I run asterisk the log file gives me
Feb 17 12:16:21 ERROR[6919] libq931: visdn0: setsockopt(SO_BINDTODEVICE): Bad
file descriptor
Feb 17 12:16:21 WARNING[6919] intf.c: Cannot open interface visdn0, skipping
what else can I check?
Regards Allan Gee
Phone: +27 21 4644400 Ext. 103
www.equation.co.za
_______________________________________________
Visdn-hackers mailing list
[email protected]
https://mailman.uli.it/mailman/listinfo/visdn-hackers
