I have installed the latest devel (667) driver on a clean install of Asterisk @ Home configuring a Beronet 4 port ISDN BRI card (hfc-4s). The setup is TE mode, P2P. This was done on 2 ISDN 2e lines supplied by British Telecom. The ISDN lines connect to Marconi System X switches in the exchange. (The UK uses Marconi System X switches and Erricsson switches in the exchange).
Pretty much a normal install following instructions posted on the mail list. Tested incoming and outgoing calls. Good clear lines with little echo. Only one issue. Every few seconds there is a click sound. It is very regular. This continues whether there is someone speaking or not.
I'll have to use an older revision. Any suggestions (I will try the release 0.15 first then upgrade slowly if there are no issues.) ?
Thanks
Rehan
_______________________________________________ Visdn-hackers mailing list [email protected] https://mailman.uli.it/mailman/listinfo/visdn-hackers
