|
Try this for more information: http://www.somemore.com/tips.html See the bottom of the documentation. Try increasing the T3 timer to
3000. Can you ask your provider to reset the line? Rehan -----Original Message----- From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Matthias Urlichs Sent: 23 July 2006 22:45 Subject: [Visdn-hackers] L1 start-up error Hi, I'm (finally...) trying to setup my visdn box. Unfortunately, I can't
seem to Instead, I see this, every ten seconds (in asterisk, debug turned on): -- visdn2: MPH-ERROR-INDICATION: 228 -- set timeout = -1 -- visdn2: MPH-ACTIVATE-INDICATION -- set timeout = -1 -- visdn2: MPH-ERROR-INDICATION: 228 -- set timeout = -1 -- visdn2: MPH-ERROR-INDICATION: 228 -- set timeout = -1 -- visdn2: MPH-ACTIVATE-INDICATION -- set timeout = -1 -- visdn2: MPH-ERROR-INDICATION: 228 -- set timeout = -1 /etc/visdn/device-pci-* states: <netdev visdn2> protocol lapd role TE mode P2P </netdev> <port st0> attribute role TE attribute timer_t1 1500 attribute timer_t3 1500 <chan D> connectmodule netdev visdn2 </chan> <chan E> connectmodule netdev visdn2 echo </chan> </port> visdn_configurator reports no problems, the files in /sys look sane,
... The ISDN cable is OK -- it works fine on my old (mISDN) system. This is kernel 2.6.15 (Ubuntu Dapper), latest visdn snapshot (669). ... so what do I do now? -- Matthias Urlichs | {M:U} IT Design @ m-u-it.de |
[EMAIL PROTECTED] Disclaimer: Das Zitat wurde zufällig ausgewählt. |
http://smurf.noris.de - - Aus Murphy's Gesetze: Dein Produkt wird von Fachzeitschriften so lange nicht getestet, bis Konkurrenzprodukte auf den Markt gebracht werden, die besser sind. _______________________________________________ Visdn-hackers mailing list https://mailman.uli.it/mailman/listinfo/visdn-hackers |
_______________________________________________ Visdn-hackers mailing list [email protected] https://mailman.uli.it/mailman/listinfo/visdn-hackers
