(I don't think this went through the first time I tried...I apologize if this is a repeat!)a
I have darwin installed on an intel x86 machine, including xfree86. Now I am trying to build Xvnc. I had to create a symlink so that make could find cpp, but then the build seemed to go ok. But no binary resulted. Looking back through the build messages, I see a lot of errors like this: ../../config/makedepend/makedepend: warning: imake.c: 7: #error architecture not supported ../../config/makedepend/makedepend: warning: include.c: 34: #error architecture not supported Can someone point me off in the right direction for resolving this? Thanks, Eric --------------------------------------------------------------------- To unsubscribe, mail [EMAIL PROTECTED] with the line: 'unsubscribe vnc-list' in the message BODY See also: http://www.uk.research.att.com/vnc/intouch.html ---------------------------------------------------------------------
