The input signal is reasonably clean. I need to probe all the outputs of this chip I think. It looks like this output ONLY goes to the test point, which is somewhat odd!
Regards, David Partridge -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of m k Sent: 01 February 2013 07:43 To: [email protected] Subject: Re: [volt-nuts] Improving Solartron 7071 and 7081 Hi David, I looks like the gate before TP3 gets a signal from off the PCB, how clean is that? first I would put a .1u to .22u small ceramic cap between power and ground of 403 then I would look at where TP3 signal goes to, does it feed off the PCB to anywhere else? a ring below ground means an inductive kick. HCT is even faster, so it might give a bigger kick? Wrinkle _______________________________________________ volt-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.
