Op 13-8-2013 20:16, Joseph Gray schreef:
I came across a couple of old Fluke differential voltmeters that need some
work. I thought it would be best to use low thermal EMF solder on these.
I think it would be best *not* to.
As far as I know, Fluke never used any low thermal EMF solder on any of
its equipment, even
the very top-of-the-range stuff. I certainly never seen it mentioned in
any service manual
for e.g. the 720, 845, 750, 752.
Rob.
_______________________________________________
volt-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
