Hi All, I ordered two HP 5060-0258 extender cards from Tucker Electronics; they work. One extender is not quite long enough to allow access to the socket contacts with mini-grabbers, so I ordered two cards. One extender is long enough to carefully slip a voltmeter probe onto the contact area and/or grab part leads as required for test and alignment.
Does anyone else use one of these Guildline 9975 resistance bridges? If so, do you use the DB-37 connector on the back to remotely read the switch positions? Joe On 1/18/2014 7:14 AM, Joe Hobart wrote: > Does anyone have or know where I can buy or borrow a 12/24 contact extender > card > for the Guildline 9975? I have a single sided extender, but the signal > demodulator board requires a double sided extender. Of course, it is this > card > that needs additional testing and possible repair. > > Thank you, > Joe Hobart > Flagstaff, Arizona > _______________________________________________ > _______________________________________________ volt-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.
