Hi Poul-Henning,
you've misunderstood, what I've done..
I simply searched the text fragments directly in the binary file, with a
HEX-editor.
I did no SW-reverse-engineering!
I just wanted to identify, which failure (text) messages come up, when
either the config RAMs, or the cal RAM fail...
Nobody up to now reported the correct failure messages in case of
failure of the 8kB CAL RAM.
But perhaps you can tell from your reverse enginieering, what the error
message would be?
regards Frank
Am 27.03.2014 19:11, schrieb Poul-Henning Kamp:
In message <[email protected]>, Frank Stellmach writes:
So I've scanned the text fragments in the firmware file:
I have the firmware reverse engineered, and it is a fair deal
more complicated than you posit, there are both checksums
and hardware mechanisms involved.
_______________________________________________
volt-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
