Never mind, I looked in the 7061 service manual and found the resistor. Is there a recommended type of resistor for use across mains? I am thinking the carbon comp resistor should be replaced with a metal glazed film type or anything listed as flame proof.
Todd On Sat, Aug 16, 2014 at 9:28 PM, Todd Micallef <[email protected]> wrote: > > The new model is the FN372-2-22 and all pinouts appear to match based on > manufacturers datasheets. The only snag that I have run into is a 1Meg > resistor soldered across the output of the filter. I looked in the service > manual and there is no mention of this part. I know others here have > replaced the Schaffner filters and I would like to know if there is any > benefit to adding this resistor? > > > > Todd > _______________________________________________ volt-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.
