There is also one listed on Ebay for $9...
http://www.ebay.com/itm/TRW-Cinch-50-86C-30-43-Pos-Double-Wire-Wrap-PC-Edge-Connector-New-Old-Stock-/171213916405?pt=LH_DefaultDomain_0&hash=item27dd2508f5
If you have access to a PCB layout program you can easily make the circuit
board/edge tabs. OSHPARK.COM will make you three boards for $5 per square
inch. You could either make a full hard-extender or do the ribbon cable
thing... which would be fairly easy since the connectors are 0.1" spacing with
wire wrap pins and could plug two 50-pin ribbon cables directly onto the
connector (with a little futzing where the two connectors come together.
I could try and make a small edge tab board and put it on OSHPARKs "shared
projects" page where you could order them from. I would need to know the
spacing of the edge of one of the end fingers to the edge of the board. Would
also need to know the length of the edge tab.
_______________________________________________
volt-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
