That would be me... I have the boards in and they probably work with all the
cards, but they scare me... Three of the 5200 boards have +/-300V and +/-
190V on some of the pins and I don't totally trust them to handle that
properly. The ribbon cable is rated at 300V and the box headers are
(supposedly) 1000V. There is only around .012" clearance between the etches
and the header pins they run between.
The high voltage pins are surrounded by guard pins and 190V pins. It should
work and I have tested one by applying 300VDC across both sides of the edge
connector and didn't have any arcing issues, but it still makes me rather
nervous...
_______________________________________________
volt-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
