Hi Mark.
I appreciate your concerns regarding the +- 300 volts and would be a
bit worried too.
Where is the minimal spacing you mention, is it between the card edge connector
pads or the tracks that connect these pads to the ribbon cable?
>From memory the only two boards that have the +- 300 volts on them are the
>power supply and power amplifier boards, guess I will have to drag the manual
>out again and look at what is connected to the adjacent pins.
Where to now?
I have pushed my 5200a aside for the last month waiting to see what develops on
the extender front, however I would like to get it going soon but I have at
least one problem with the attenuator board which is virtually impossible to
troubleshoot without some type of extender.
I have managed to get hold of two 34/86 pin card edge sockets but I need the
double sided card edge connector to go into the socket on the main chassis to
be able to fabricate my own extender.
Ken Goodhew.
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
_______________________________________________
volt-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
