I did the same for my Datron 4700 and Valhalla 2724a. I took a picture of that ebay listing to the locksmith for a laugh. The lock on the 4700 came out easily once the outer threaded cap of the lock was removed.
Todd Sent from my iPad > On Dec 7, 2014, at 11:10, David C. Partridge <david.partri...@perdrix.co.uk> > wrote: > > 1) Can you get into the case and remove the lock-switch? If yes, see 2) > > 2) Take lock to lock-smith, get key made. If they can't make a key to fit, > they're not a lock-smith! > > Regards, > David Partridge > -----Original Message----- > From: volt-nuts [mailto:volt-nuts-boun...@febo.com] On Behalf Of > ludger.len...@gmx.de > Sent: 07 December 2014 14:20 > To: Discussion of precise voltage measurement > Subject: [volt-nuts] Datron 1281 calibration enable key > > I am searching for the calibration enable key for my Datron 1281. > At EBAY one key for the Wavetek 4808 Calibrator is offered. > > Does anybody know if this key fits also to the Datron 1281? > > Thanks for Help. > > PeLuLe / Germany > _______________________________________________ > volt-nuts mailing list -- volt-nuts@febo.com To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts > and follow the instructions there. > > _______________________________________________ > volt-nuts mailing list -- volt-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts > and follow the instructions there. _______________________________________________ volt-nuts mailing list -- volt-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.
